Probe Bottle - Vestfrost R-90 Notice D'utilisation

18 Vestfrostsolutions.com

Probe bottle

100 ml
Only available with DIN 58345 kit
To locate the probe bottle, see chapter
Refrigerator component.
It is important to prepare the probe bottle
before use.
Steps:
1.
The probe bottle is placed like shown in
top and bottom.
2.
Remove the probe bottle and fill it with
100ml with a mixture of water and
alcohol (min. 70%) in ration 1:1 (if you
are use to use other products for probe
bottle you may use this).
3.
Place the probe bottle back in the
refrigerator and put the sensor in the
water, and make sure that all of the
metal on the sensor is covered.
Note!
The mixture in the probe bottle shall be
checked and refilled on a regular basis.
EN