Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
AT THIS MOMENT, IT IS NECESSARY TO POUR THE SCALE REMOVER
LIQUID INTO THE FILLER CAP.
Prepare the solution as shown on the scale remover liquid.
Pour the scale remover in the special tray until the circuit is completely full
(according to the sauna version, the scale remover required will vary from
500cc to 800cc).
The start of the scale removal process is shown by a reduction in the flashing
frequency of the "
" button (1 flash every two seconds).
Remember to replace the cap of the decalcifier's topping up tube.
The scale removal process takes about two hours and for all this time, the
dial on the "
" button will continue to flash at low frequency.
The cycle should be run preferably during night hours, or at least when the
sauna is not in use.
The cabin can still be used with the shower or multifunctions while the
descaling cycle is running.
At the end of the descaling phase, the descale luminous ring turns off, and
only the luminous ring around the sauna button remains lit.
The sauna can now be used again.
SAUNA J
11
Publicité
Table des Matières
