emerio SEW-121816 Mode D'emploi page 9

SEWING
1. Turn the hand wheel counterclockwise to raise the needle to its highest position.
2. Raise the presser foot lifter and place the fabric you want to sew under the presser foot (Fig.15).
3. Lower down the presser foot. (Fig.16).
4. Press the stitch selection button to select the stitch pattern you want, you can see the number of stitch
you select on the digital display. Every stitch has its recommended stitch density, which is listed besides
the stitch number on the stitch panel. Rotate the stitch density dial to select the stitch density according to
the stitch you select.
Caution:

Before you change the stitch pattern, please turn off the switch and turn the hand wheel to raise the
needle all the way up so it doesn't get stuck and bent.

Changing the stitch pattern is not allowed when the machine is running, otherwise the needle and/or
machine may damage.
5. Turn the hand wheel several times to make sure there is no jamming in the stitches.
6. Slide the power switch to the position "ON", and step on the foot pedal. The machine will start sewing.
Adjust the sewing speed through the force you step on with. We recommend the low speed for beginners.
7. When you finish the sewing, turn off the switch, unplug the adapter, turn the hand wheel to raise the
needle all the way up, lift the presser foot, and then gently remove the fabric from the sewing machine,
and cut the thread with the thread cutter (Fig.17 & Fig.18).
Tips:

Please turn the hand wheel if it is difficult to remove the fabric, and then pull out the fabric gently.

If the thread had tangled or jammed, please turn the hand wheel and simultaneously pull the thread
slightly to release the thread. Bottom bobbin mechanism is a more precise part, inappropriate actions
may damage it. Please to not push or pull it by finger or any tools.
Fig.12
Fig.15
Fig.17
Fig.13
- 8 -
Fig.14
Fig.16
Fig.18