Winding The Bobbin - emerio SEW-121816 Mode D'emploi

WINDING THE BOBBIN

1. Put a spool of thread on spool pin. (Fig.27)
2. Guide the thread through the bobbin winder tension disk on the upper side of the machine. (Fig.28 &
Fig.29)
3. Lead the thread through the small hole of the empty bobbin and hold the thread on hand. Put the bobbin
on the bobbin winder pin. (Fig.30)
4. Push the bobbin winder pin towards the bobbin winder stop. (Fig.31)
5. Turn on the machine and use foot pedal to wind the bobbin. Hold the thread end on hand for several
seconds in case the thread break away from the bobbin. When the thickness of thread on the bobbin gets
close to the bobbin winder stop, the machine will stop automatically.(Fig.32)
6. Release the foot pedal and turn off the machine. Remove the bobbin and cut off the thread. Slide the
thread winder pin to the left. (Fig.33)
Note:
You can adjust a little the position of the bobbin winder stop with a screwdriver, to change the thickness of
bobbin thread. Use the screwdriver properly. Just turn the screw a little, never rotate the screw off! (Fig.34)
Fig.24
Fig.27
Fig.30
Fig.33
Fig.25
Fig.28
Fig.31
Fig.34
- 12 -
Fig.26
Fig.29
Fig.32