emerio SEW-121816 Mode D'emploi page 7

3. Removing and Installing the presser foot locking device
Use a screwdriver to turn the thumb screw counterclockwise, the screw is loosened and the presser foot
locking device can be removed. (Fig.5)
To install the presser foot locking device back, just align the locking device to the pole and fit the thumb screw
into the hole on the pole. Tighten the screw by turning it clockwise with a screwdriver. (Fig.6)
THREADING THE SEWING MACHINE
1. Threading upper thread
Caution: Always switch off the appliance and disconnect the appliance from the power supply when threading
the machine.
1) Turn the hand wheel to raise the needle to its highest position.
2) Put a spool on the thread spindle, put on the thread spindle cover and then pull out the thread.
3) Pull the thread and let it pass through the bobbin winder tension disk. (mark ① in the pic. below)
4) Guide the thread through the groove and pull it up towards the chromed take-up lever. (mark ② in the
pic. below)
5) Feed the thread through the hole in the chromed lever and pull it straight down towards the needle. (mark
③ in the pic. below)
6) Feed the thread through the hole in the needle holder, then through the eye of the needle from the front
side to the back and pull out 10cm to the back. (marks ④ & ⑤ in the pic. below)
Fig.5
- 6 -
Fig.6