Error Codes - saro SVM Manuel D'utilisation

BEDIENUNGSANLEITUNG/ USER MANUAL/ MANUEL D'UTILISATION
List of fuses
Fuses have been placed where the power comes onto the component board
Fuses have been placed on transformers (control and seal)
Two fuses have been placed on the control circuit.
Due to different mains voltages and machine models there is a variety of fuse types that can be present in the machine.
Refer to the specifications of the relevant component for the correct types and values of fuses for replacement, or
contact the supplier or SARO .
Caution, to avoid fire and/or other irreparable damage to the machine, replacement fuses must
always be of the same type with the same value as the fuses being replaced !!
Spanning
Caution, the maximum allowable voltage fluctuation is ± 10% of the official voltage stated on the
type tag.

ERROR CODES

The control is programmed with an error code. This error code indicates there is a problem with the proper function of
the lid switch of there is a user fault.
F1: This code indicates that the cycle (lid switch) will be interrupted prematurely.
Example: the cover of the machine closes after starting, but before sufficient vacuum is present to keep the cover closed
the operator lets go of the cover. The F1 code will now be shown on the display.
If this keeps happening please contact the supplier or your dealer
Version 12.10 Art. 0894552
Saro
55