saro SVM Manuel D'utilisation page 37

BEDIENUNGSANLEITUNG/ USER MANUAL/ MANUEL D'UTILISATION
TRANSPARENT LID
Never locate the machine near a heat source. This can cause damage to the lid (cracks).
Never place hot, sharp, or heavy objects on the lid. These can cause damage to the cover (cracks) in the long run.
Always clean the cover with solvent-free cleaning agents. Solvents can damage the lid.
Check at least once a week if there are cracks in the lid. If cracks are visible in the lid then the machine must
IMMEDIATELY be turned off and not used again until the lid has been replaced. Continuing to work with a cracked lid
can cause the lid to implode. All guarantees and/or liability expire in the case of accidents and/or damage caused by
working with a cracked lid.
Replace the transparent cover every 4 years as a precautionary measure as a standard maintenance interval.
VACUUM PUMP
Regularly check the level and quality of the oil in the pump. If too little oil or the quality of the oil is bad (turbid),
replace or top up the oil before operating the machine (see page 46). Let the pump conditioning program run at least
one full cycle before replacing the oil (see page 45).
Use the right type of oil for the pump when replacing or topping up (see page 46).
Use the conditioning program at least once a week to enhance correct and long-lasting pump operation (see page
45).
WARNING SIGNS ON THE MACHINE !!!
Version 12.10 Art. 0894552
ONLY use the prescribed power supply voltage.
Insert the plug firmly into the mains wall socket.
Always connect the machine to an earthed wall socket.
Always remove the plug during maintenance or when the machine is not in use for extended periods.
Saro
37