Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation
DIN Front-mount
Installation with the rubber bush
Dashboard
53
Removing the unit
182
Insert the supplied extraction keys into the
unit, as shown in the figure, until they click
into place. Keeping the keys pressed against
the sides of the unit, pull the unit out.
Holder
After inserting the holder into the
dash-board, then select the
appropriate tabs according to the
thickness of the dash-board
material and bend them.
(Install as firmly as possible using
the top and bottom tabs. To secure,
bend the tabs 90 degrees.)
Rubber bush
Screw
Frame
Insert the release pin into the hole
in the bottom of the frame and pull
out to remove the frame. (When
reattaching the frame, point the
side with a groove downwards and
attach it.)
En
13
Publicité
Chapitres
Table des Matières
