Operating The Unit; Steam Function; Sweep Function - UFESA EM5000 Mode D'emploi

16 Cleaning pad
17
Electrobrush on/off button
18
Indicator lights (calor – heating, vapor – steam,
barrer – electrobrush)
19
calor on/off switch

Operating the unit

The unit has two steam functions that you can choose
from. The steam mop generates hot steam for easy
removal of dirt from hard floors, but may also be used
as an electrobrush for sweeping hard floors or carpets.
Assembling the tube with the holder
● Remove all the parts from the package.
1
Put the end of the tube into the steam mop base
and push the tube base together until it locks into place.
2
Wind the excess cord around the cord wraps.

Sweep function

1
Connect the unit to an appropriate outlet.
2
Press the button to turn on the electrobrush.
The electrobrush may be used on hard
level floors both with or without the
cleaning pad.
On short pile carpets, the electrobrush
should be used without the cleaning pad.
3
After use turn off the electrobrush by pressing the
button.
4
To empty the waste container, lift it by the holder
located in the upper lid.
5
Push the release button located on the back of the
container to remove the waste.
6
Close the emptied waste container and refit it until
it clicks into place.
Before using the sweep function make
sure that the waste container is fitted in
the unit.
Do not lift the electrobrush from the floor
when in operation.

Steam function

To use the steam function, follow the instructions below.
1
Match and attach the micro-fibre cloth to the
cleaning pad.
Make sure that the velcros on the
cleaning pad and on the cloth fit well.
2
To fit the cleaning pad onto the unit, gently lower
the cleaning head onto the cleaning pad, so that
head wheels click into the notch in the cleaning pad.
To detach the cleaning pad, hold the pad release tab
with your foot and lift the cleaning head.
B
Never use the mop with the steam
function without the micro-fibre cloth
attached.
3
Remove the water tank by releasing the hook of
the water tank and pulling the tank towards you.
D
4
Turn the water tank upside down and unscrew the
cap. Fill the tank with water, replace the cap (make sure
that it is screwed all the way in) and refit the tank.
Do not use the steam mop with the
steam function with no water in the tank.
● Plug in the unit to an appropriate outlet.
5
Slide the calor switch to the on position.
6
The unit will start heating water. The calor indicator
light will illuminate.
When the vapor indicator light
illuminates the unit is ready for
operation with the steam function.
7
To start operation, press and hold the trigger.
The mop will stop steaming when you
release the trigger.
If the unit runs out of water during
operation, slide the calor switch to the
off position and refill the water tank
(see sections and ).
4 5
F