Marathon MBWC24 Manuel D'utilisation Et D'entretien page 7

Models: MBWC24 / MWC24-D
1. Remove the handle packed inside the wine and/or beverage cooler and remove the 2pcs 4x35 screws from
accessory bag
2. Pull open the gasket (door seal) from the side of door and insert screws into the 2 handle holes as shown
below. Tighten with a Philips screwdriver until firmly attached. IMPORTANT-DO NOT OVER TIGHTEN
Once positioned, plug the wine & beverage cooler into the power outlet and turn "ON" by pressing the
for 3 seconds.
"Power Button"
3s
When you use your Marathon wine and beverage cooler for the first time (or restart the appliance after hav-
ing it shut off for a long time), there will be a few degrees variance between the temperature you have se-
lected and the one indicated on the LED readout. This is normal and will adjust to the desired temperature
once the compressor and cooling system has been running for several hours.
Important: If the unit is unplugged, power is lost, or turned off, wait 3 to 5 minutes before restarting the
unit. The compressor will not re-start immediately and requires this time to automatically re-start.
Frost Free Fan Cooled Operation
Your Marathon is engineered with a high efficiency compressor cooling system that uses a fan to cool and
regulate your desired temperature setting and is Frost Free. This means you never have to worry about
defrosting your wine and beverage cooler and it will provide years of hassle free enjoyment. Like all Frost
Free, compressor appliances, you will hear the fan operating and the compressor cycling on and off while it
also defrosts itself. The following sounds will most likely occur during normal operation:
• Gurgling sound - caused by the refrigerant flowing through the appliance's coils.
• Cracking/popping sounds - resulting from the contraction and expansion of the refrigerant gas to produce cold.
• Fan operating sound - to circulate the air within the wine cellar.
Use and Care
MBWC24 | MWD24-D | MBWC24-2D