Marathon MBWC24 Manuel D'utilisation Et D'entretien page 6

Handle Assembly and Ventilation Grill
Installing the Stainless Steel Handle(s) and Ventilation Grill (MBWC24-2D)
To protect your wine and/or beverage cooler while in transit, we have carefully packed the heavy duty stain-
less steel handles inside the wine cooler for you to assemble. Please see the simple directions below, for any
questions or concerns, please contact us.
French Door Model MBWC24-2D
Please note that for model MBWC24-2D, the legs are adjustable to 2 inches to assist with varied counter
heights. A minimum of 34.5" height is required for the front ventilation plate to be properly secured once
installed. The stainless front ventilation grill is packaged separately in the wine cooler. Once the wine and
beverage cooler is leveled and place into the location, the front ventilation grill is easily installed and se-
cured by the 4 stainless screws included.
MBWC24-2D is designed for standard counter high installations which requires adjusting the legs to 34.5"
in order to fit the standard 5.25" ventilation grill. If you have a custom installation between 32.5"-34.5", a
smaller 3.25" ventilation grill is available by contacting customerservice@stirlingmarathon.com
Model: MBWC24-2D
1. Remove the two handles packed inside the wine and beverage cooler and remove the 4pcs 4x35 screws
from accessory bag
2. Pull open the gasket (door seal) from the side of door and insert screws into the 2 handle holes as shown
below. Tighten with a Philips screwdriver until firmly attached. IMPORTANT-DO NOT OVER TIGHTEN