Christopeit Sport CX 4 Notice De Montage Et D'utilisation page 23

Step 6:
Attach the handle grip (3) and computer (1) at support (25).
1. Place the handle grip (3) against the support (25) so that the
holes are aligned and push the pulse cable (4) through the holes
of handlebar support (25) to top position.
2. Push a washer (13) onto each screw (17), push them through
the holes and tighten the handgrip bar (3) at handlebar support
(25) firmly.
3. Put the plug of connection cable (28) into the plug from computer
(1) backside.
4. Insert the plug of pulse connection cable (4) to the jack of the
computer (1) and attach the computer (1) to top monitor bracket
of front post (25) with screws (16). (Attention: Ensure that the
cable loom are not crunched or pinched during installation.)
5. Mount computer cover set (7-1+7-2) to the handle bar support
(25) and secure with screws (8+22).
Step 7:
Attach the power.
1. Please insert the plug of adaptor (93) to the power plug (69) at
end of chain guard (60).
2. Please insert the plug of adaptor (93) to the jack of wall power
(230V~50Hz).
Step 8:
Checks
1. Check the correct installation and function of all screwed and
plug connections. Installation is thereby complete.
2. When everything is in order, familiarize yourself with the ma-
chine at a low resistance setting and make your individual
adjustments.
Note: Please keep the tool set and the instructions in a safe place
as these may be required for repairs or spare parts orders becoming
necessary later.
23