Installation Of Accessories - Paoli DP 5000 TI MARK II Mode D'emploi

REGULATION OF
THE AIR PRESSURE
L Before the use, always perform a
dynamic adjustment of the supply air
pressure (view figure
supply air pressure on the low pressure
gauge turning the adjusting screw of the
air pressure regulator while keeping the
trigger pressed.
L Do not exceed the maximum supply
air pressure of 25bar (with wheel gun
running).

INSTALLATION OF ACCESSORIES

Before changing an accessory, always make
sure that the air supply line is depressurized (no
air pressure), and only after disconnecting the
wheel gun and replace it. Use only accessories
suitable for the job (view our catalogue for
accessories). Use only impact sockets with a
hole for the locking pin.
Do not use chrome sockets or for manual use.
Do not use square drive adapters (reductions
or multiplies).
Always check that the locking pin of the socket
is present and secured firmly. To install the
wheel nut socket, proceed as follows:
L Mark each clutch cover with the wheel gun's
serial number.
L Remove the four clutch cover (hammer
case) screws, discard lock washers.
L Holding the 1" square drive, remove the
anvil shank, clutch cover bearing and clutch
cover from gun. Clutch spring should
remain with clutch shaft, clutch plate and
clutch housing. Retain the anvil shank,
clutch cover bearing and clutch cover as an
assembled unit.
ENGLISH
6
OPERATING AND MAINTENANCE MANUAL
Fig.5). Adjust the
HANDLING
L Please pay attention to your wheel gun
selector plate type (3 port or 2 port
version).
L Slide the rotation reverse shaft
Fig.1-I) and push the trigger
Fig.1-C). See the figure
the rotation direction of the square drive.
L Avoid accidental starting, being careful not
to unwittingly act on the trigger
Fig1-C).
L Using an appropriately sized aluminum
block, support the 1" square drive from
the bottom. This will provide the base for
pressing the socket onto the square drive.
Make sure the block is tall enough to allow
clearance for the clutch cover.
L In ideal situations, an aluminum block
should be machined to fit either the I.D.
or the surface of the socket. This will be
used for pressing the socket onto the
square drive. Special attention must be
taken to assure the inner O-ring groove
(retention ring) is not damaged by a tool
used on the socket I.D.. A tool used on the
magnet surface (i.e. for wheel nut sockets
with magnets) should also fit properly to
prevent damage to the magnets. In certain
situations a thick block of aluminum can
be used to press directly on the teeth
of the socket (i.e. for wheel nut sockets
with fingers) for installation. This is not a
recommended practice and should only
be used when a proper press tool cannot
readily be made.
(see figure
(view figure
Fig.4 to identify
(view figure