Reverse Door Operation - Brandt BFU4425SW Guide D'installation Et D'utilisation

REVERSE DOOR OPERATION

1) Remove the 2 screws on the back:
2) Carefully lift the top cover 5 cm away
from the freezer, and then pull out the
terminal. Then remove the top cover
away:
3) Remove the three screws, and then
remove the upper hinge that holds the
door in place. Lift the door and place it
on a padded surface to prevent it from
scratching:
4) . Remove the screws and bottom
hinge. Then remove the adjustable
feet from both sides:
5) Unscrew and remove the bottom hinge
pin, turn the bracket over and replace it:
6) Refit the bracket fitting the bottom
hinge pin. Replace both adjustable feet:
7) Place the door back on. Ensure the
door is aligned horizontally and vertically so
that the seals are closed on all sides before
finally tightening the top hinge:
8) Connect the terminals onto the display
board, and then put top cover back:
9) Screw the 2 screws on the back:
10) With the door closed, check that the
door is aligned horizontally and vertically and
that the seals are closed on all sides before
finally tightening the bottom hinge. Re-adjust
the levelling feet as needed:
23