Troubleshooting - VOLTCRAFT PSW 1000 Série Notice D'emploi

10. TrOuBLEShOOTING

Inverter cannot be switched on, "Power" LEd is not lit.
• The rechargeable battery used for operation is flat. Connect the inverter to another, fully
charged rechargeable battery.
• The polarity was swapped at connection. Check the wiring.
• The cable connections with the rechargeable battery are not correct; e.g. the connection
cable is not screwed on. Tighten the screws of the terminal clamps.
The inverter works only with a consumer with a lower power consumption.
• The connection cable to the rechargeable battery is too long or the line cross-section is too
small. Replace the connection cable by a shorter one; use a cable with a larger line cross-
section.
• The consumer's power consumption is too high for the inverter.
• The consumer's power consumption is too high when starting up.
The connected consumer is not working and the "Fault" LEd is lit.
• The consumer's power consumption is too high for the inverter; overload protection has
been activated.
• The consumer's power consumption is too high when starting up; overload protection has
been activated.
37