Listening To An External Source; Sleep Timer - Teac TC-X350i Mode D'emploi

Listening to an External Source

See pages 8, 9 "Connections".
1
Connecting to a cassette tape deck etc.
Connect a cassette tape deck etc. to the AUX 1 IN jacks
using commercially available RCA cables.
(pages 8, 9 D )
Make sure to connect:
White plug White jack (L: left channel)
e
Red plug Red jack (R: right channel)
e
Connecting to a portable audio player
Connect the PHONES jack or audio output jack of a
por table audio player to the AUX 2 jack using
commercially available stereo mini plug cable. (pages 8, 9
) .
B
2
Press the SOURCE button to select "AUX1" or "AUX2".
o You can also select "AUX1" or "AUX2" by pressing the AUX button
on the remote control unit once or twice.
3
Play the source, and adjust the volume using the VOLUME
knob of the TC-X350i and the connected audio player.
o When using the PHONES jack of your mini player, you must
adjust the volume of the mini-player or you may hear no sound
from your TC-X350i.
o Turning the volume of the mini player up too high may cause
the sound from your TC-X350i to be distorted. If this is the
case, reduce the volume of the mini player until the distortion
stops. And then adjust the volume level of the TC-X350i to a
comfortable listening level.
o When the source is "AUX1" or "AUX2", if you press the STANDBY/
ON button to turn the unit to standby, it will take a few seconds
to stop the sound from connected subwoofer.
26

Sleep Timer

You can set the sleep timer so the unit turns itself to standby after a
specified amount of time.
Each time the SLEEP button is pressed, the setting is changed
as follows:
10 (min)
20 (min)
30 (min)
60 (min)
90 (min)
OFF
o Select "OFF" to cancel the sleep timer.
o The display is dimmed during the sleep timer is activated.
o If you want to check the time remaining until the unit is switched
to standby, press the SLEEP button once. The remaining time will
be displayed for a few seconds.
o This operation is available in every sound source.