Sony UP-DF750 Mode D'emploi page 7

Recommended separation distances between portable and mobile RF communications equipment and the
The UP-DF750 is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of the UP-DF750 can help prevent electromagnetic interference by maintaining a minimum distance
between portable and mobile RF communications equipment (Transmitters) and the UP-DF750 as recommended below,
according to the maximum output power of the communications equipment.
Rated maximum output power of transmitter
W
0.01
0.1
1
10
100
For transmitters rated a maximum output power not listed above, the recommended separation distance d in meters (m) can
be estimated using the equation applicable to the frequency of the transmitter, where P is the maximum output power rating
of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and
reflection from structures, objects and people.
Caution
When you dispose of the unit or accessories, you must
obey the laws in the relative area or country and the
regulations in the relative hospital.
When the unit is moved, place the unit in a horizontal
position and lift it by holding corners of the bottom plate
with 4 people.
Do not move the unit in a vertical position.
WARNING on power connection
Use a proper power cord for your local power supply.
1. Use the approved Power Cord (3-core mains lead) /
Appliance Connector / Plug with earthing-contacts that
conforms to the safety regulations of each country if
applicable.
2. Use the Power Cord (3-core mains lead) / Appliance
Connector / Plug conforming to the proper ratings
(Voltage, Ampere).
If you have questions on the use of the above Power Cord
/ Appliance Connector / Plug, please consult a qualified
service personnel.
UP-DF750
Separation distance according to frequency of transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz
d = 1.2 √P
0.12
0.38
1.2
3.8
12
WARNING on power connection for
medical use
Please use the following power supply cord.
With connectors (plug or female) and cord types other than
those indicated in this table, use the power supply cord that
is approved for use in your area.
Plug Type
Cord type
Minimum Rating for Plug
and Appliance Couplers
Safety approval
*Note: Grounding reliability can only be achieved when the equipment is
connected to an equivalent receptacle marked 'Hospital Only' or 'Hospi-
tal Grade'.
For the customers in Europe
Hereby, Sony Corporation, declares that this UP-DF750/
Digital Film Imager is in compliance with the essential
requirements and other relevant provisions of Directive
1999/5/EC.
For details, please access the following URL :
http://www.compliance.sony.de/
This product has been manufactured by or on behalf of
Sony Corporation, 1-7-1 Konan Minato-ku Tokyo, 108-
0075 Japan. Inquiries related to product compliance based
on European Union legislation shall be addressed to the
authorized representative, Sony Deutschland GmbH,
Hedelfinger Strasse 61, 70327 Stuttgart, Germany.
For any service or guarantee matters, please refer to the
addresses provided in the separate service or guarantee
documents.
m
800 MHz to 2.5 GHz
d = 1.2 √P d = 2.3 √P
0.12
0.38
1.2
3.8
12
United States and Canada
HOSPITAL GRADE*
Min.Type SJT
Min.18 AWG
10A/125V
UL Listed and CSA
0.23
0.73
2.3
7.3
23
7