Novy 864 Mode D'emploi Et D'installation page 20

Replacement of the fluorescent lighting
Remove first the electrical plug from the electrical
point.
Remove the (onderplaat)
• Open the cover plate (A) by pulling it down.
• Remove the cover plate (A) by converting the
adjusting clips (B). Don't loosen the screws
completely!
• Click the cover plate (A) loose with a light
descending push.
• When you want to replace the cover plate (A)
don't forget to replace the adjusting clips over
the plugs and to tighten the screws.
Remove the grease filter
• Remove the grease filter to get acces to
the screws witch hold the glass panels (see
maintenance).
Remove the glass panels
• Loosen First the screws before you remove the
glass panels (A).
• Tip the glass panel (A) over the filterholder (B)
• Watch out: Support the glass panel with the
integrated command, so the cable (C) that lies
underneath doens't get damaged.
Cleaning the glass panels and cover plate
• Don't put the panels and the cover plate in the
dishwasher and don't plunge them in water
completely.
• Keep the control dry while cleaning the glass
panel.
Replacement of the lights
• Turn the fluorescent lights with a quarter turn to
take it out of its support.
• Place the new light in its support and turn again
witha quarter turn until you hear a clicking
sound.
Model
Novy reference
Reference lamp
Model
Novy reference
Reference lamp
Replacement of the starter
894/895
894.025
T5 L13W/840
896/897/898/899
898.025
T8 F25W/33"/840
EN 20