Clg140/ Clg160 - Wall Mount; Clg140/ Clg160 - Tree Mount - Monitor Audio CLIMATE GARDEN Série Guide D'installation

CLG140/ CLG160 - Wall Mount

1
Fix the base of the mount to the intended
location with a single screw (i), then
insert the ball fixing arm and top half of the mount
assembly, attach loosely with four screws (ii).
i

CLG140/ CLG160 - Tree Mount

1 Assemble the two halves of the mount
with the ball fixing arm in the middle and
secure it together using the supplied nuts and bolts
supplied with the mount.
4
the CLG140/ CLG160 (i) onto the bracket and fit the
grub screws (ii) but do not fully tighten. Adjust the
CLG140/ CLG160 to the desired direction/ angle
and tighten the four mount screws (refer to step 1)
followed by the grub screws (ii) to secure in place.
ii
HINT: To assist in threading the speaker cable
through the mount we would advise having the
ball fixing arm angled upwards.
of the mount. Wrap this around the intended tree and
fasten the belt tightly to prevent movement.
Climate Garden Series
Feed the speaker cable into the bracket
2
and out through the cable exit hole. Place
i
2 A tree belt (not included) can now be
threaded through the opening in the sides
ii