Installing Ma Presets On Your Crown Cdi 2000 Amplifier - Monitor Audio CLIMATE GARDEN Série Guide D'installation

Installing MA Presets on your Crown CDi
2000Amplifier
1. Download Monitor Audio's preset DSP settings for your
Crown CDi 2000 amplifier, available from our website:
www.monitoraudio.com
2. Download the software HiQnet Audio Architect from the
website: http://audioarchitect.harmanpro.com/en-
US/software
3. Open the downloaded zip folder, extract the executable
file to your desktop and run it, proceeding through the
steps of the Installation Wizard.
4. Once installation is complete launch Audio Architect.
5. Close the 'Crash Reporting Disclaimer' and ' A pplication
Options' window. You can now select your network
connection, or to skip this step, simply close the window.
6. Connect the Crown CDi 2000 via USB cable to your
computer and switch on the power button, the ready
LED and power button will become illuminated.
7. Once discovered a pop up will appear in Audio
Architect, check ' A dd discovered devices to the Venue
automatically' is ticked and then press close.
8. Your Crown CDi 2000 will now appear in the application
window and the 'Go Online' button will become
illuminated. Press 'Go Online' .
HINT: Maximise the Audio Architect application
window to see the buttons as they are shown in
these steps.
9. Press the 'R' (Recall) button, circled below.
10. Select the amp with a left click, then right click to show
the drop down options, press 'Open Device File...' .
11. Open the Monitor Audio preset file.
12. You have now successfully installed our Monitor Audio
presets on your Crown CDi 2000.
NOTE: There is no notification of this being
successful.
monitoraudio.com 7