Installation; Clg-W12 - Monitor Audio CLIMATE GARDEN Série Guide D'installation

Installation

CLG-W12

1 Dig a hole in the intended location for the
subwoofer and fill the base of the hole with
sharp sand. This is to improve stability, assist in
levelling and prevent the sub from rocking in place.
Approximate hole dimensions (H x W x D):
600 x 600 x 400mm
Sand depth: 150mm (6")
3 Dig a shallow trench along the path of where
you wish to run the subwoofer's speaker
cables. If using the CLG140/ CLG160 speakers there
is no reason the cables for these cannot be doubled
up in the same trench as the subwoofer's speaker
cables.
NOTE: Ensure the system is tested and working correctly before filling in around the subwoofer and cable tenches.
NOTE: The bass from the CLG-W12 will not be as full or prominent until the hole is filled in.
2
Sharp sand
From previous
speaker/ amp
Climate Garden Series
Place the subwoofer in the hole and push it
2
into the sand so that it stays still and can be
levelled/ made square.
4 Connect cables to subwoofer. For 100/70v
lines (such as the Crown CDi 2000) connect
to the black and red cables, for conventional 8 ohm
lines connect to the yellow and black. Where black
is the negative.
To CLG-W12
To Next CLG-W12
(optional)
opposite) or appropriate weather proof junction box
(not included).
Note: Ensure that no '-' and '+' strands are
touching each other as this will cause a short
circuit that could damage your amplifer.
Connections
should be made
with either
silicone filled
wire connectors
(example