Blue connect Mode D'emploi page 18

Blue Fit50 installation
NB: Feel free to ask your pool specialist for advice in case of any doubt.
A. Find the correct location
Make sure to always place the Blue Fit50 after the filter (to avoid damaging the probes) and before
your product injection system or electrolysis (to avoid altering the measures taken by the
Blue Connect).
B. Set up
1.
Turn off the filtration system.
2.
With a 40mm diameter hole saw, drill a hole in the upper part of the pipe.
Note: The Blue Connect must be in vertical position, with the probe downwards.
3.
Place both parts of the hose clamp on each side of the pipe so that the holes coincide, and
screw the hose clamp.
4.
Screw the Blue Connect.
18