Blue connect Mode D'emploi page 11

C. Probe replacement
The probe needs to be replaced approximately every two years
new one.
NB: To ensure maximum longevity of the probe, keep it for as long as possible in a humid environment.
If you take the device out of the water, you must screw it to the storage cap with KCl (saturated
potassium chloride), pH4 or, as a last resort, running water with a good amount of cooking salt.
The box includes:
Installation:
1.
In the app, in "Settings" » "My Blue Connect" » "Probe settings", press "Probe replacement".
2.
Take out Blue Connect from the water, remove the usage cap and start the procedure in a dry
and clean place.
3.
Wipe Blue Connect with a clean, absorbent cloth, paying special attention to properly
drying the bottom part of the product (where the probe is located) without touching the
sensors.
4.
Using the screwdriver, unscrew the screw located on the edge of the nut.
Make sure not to leave the probe out of the water without the storage cap filled with KCl (saturated potassium chloride), pH4
8
or, as a last resort, running water with a good amount of cooking salt.
. Please contact your reseller to get a
8
11