Blue connect Mode D'emploi page 17

Introduction
A. Overview
The Blue Fit50 is a hose clamp compatible with Blue Connect. It allows to install Blue Connect in the
technical room.
Note: Blue Fit50 is a Blue Connect accessory. It is available in the Blue Connect Plus pack, or sold
separately.
B. The box includes
C. Precautions for use
» Do not leave the Blue Connect on the Blue Fit50 when there is no water in the pipes.
» If handling on the hydraulic circuit (risk of water hammer), it is advisable to remove the Blue
Connect in order not to damage the product.
» Make sure to create a sufficient flow in your installation so that the Blue Connect can take
measures.
» Always place the Blue Connect vertically with the probe downwards.
» Blue Fit50 cannot be attached to flexible hoses
» Blue Fit50 withstands a maximum pressure of 3 bar
» Blue Fit50 is used on a 50mm pipe in Europe and a 60mm pipe for the USA and Australia.
50mm (EU) or 60mm (US / AU) hose clamp.
The seal (already placed inside the hose clamp).
One cap.
2 bolts.
17