Display
Double short fl shing
10 Cleaning
Only use a dry and solvent-free, soft cloth for cleaning.
11 Resetting factory settings
All settings will be lost when the factory settings are restored.
1. Disconnect the base station from the power supply. Pull the mains plug for this.
2. Connect the base station again to the power supply and press the System key simultaneously for 4
seconds until the LED fl shes rapidly in orange.
3. Release the System key (A)
4. Press the System key again for 4 seconds until the System key (A) lights up in green.
5. Release the System key.
9 The factory settings are reset.
12 Decommissioning
WARNING
Danger to life due to the electrical voltage at the base station!
• Only an authorised electrician may open the device.
• Always disconnect from the mains network and secure against unintended activation before opening.
• Disconnect external voltages and secure against activation.
1. Loosen all connected cables.
2. Uninstall the device and dispose of properly.
13 Disposal
Do not dispose the device with domestic waste! Electronic devices/products must be disposed
of according to the Directive for Waste Electrical and Electronic Equipment at the local collection
points for waste electronic equipment.
This manual is protected by copyright. All rights reserved. It may not be copied, reproduced, abbre-
viated or transmitted, neither in whole nor in parts, in any form, neither mechanically nor electroni-
cally, without the previous consent of the manufacturer. © 2016
Meaning
Bad radio connection to
wall thermostat
Solution
Change the position of the wall thermostat or use a
repeater.