Function - Altech V3 IP Mode D'emploi

WARNING
Danger to life due to the electrical voltage at the base station!
• Always disconnect from the mains network and secure against unintended activation before opening.
• Only an authorised electrician may open the device.
• Disconnect external voltages and secure against activation.
• Only use the product if it is in fl wless state.
• Do not operate the device without device cover.
• This unit is not intended to be used by persons (including children) with restricted physical, sensory
or mental skills or who lack experience or knowledge. If necessary, these persons must be supervised
by a person responsible for their safety or receive instructions from this person on how to use this
unit.
• Ensure that children do not play with this device or its packaging. Children must be monitored if
necessary.
• In case of emergency, disconnect the complete room-by-room temperature control system.
• Observe the performance limits of the device and its environmental conditions.
• Lay the cables of connected consumers in a way that they do not lead to dangers (e. g. trip hazards)
for persons and pets.
• Only operate the device in a dry and dust-free environment.
• Do not expose the device to the influen e of humidity, vibration, continuous solar radiation or other
types of radiation, coldness or mechanical load.

3 Function

The Altech V3 IP base station serves for the room-by-room control of a floor heating system. The base
sta-tion registers and processes the registered target and actual temperatures of connected Altech V3
IP room control units. According to this information, the rooms are always set to the specified
temperature via the connected thermal actuators. As an option, a recirculation pump is connected to
the base station to be controlled or supplied with energy by the station (depending on the model).
The range inside buildings can be strongly different from the range in open air.
Communication with other components is performed via the Homematic (HmIP) radio protocol. Radio
transmission is realised on a non-exclusive transmission path; thus, interference cannot be complete-
ly excluded. Interference can be caused e. g. by switching processes, electric motors or defective elec-
tric appliances.
Function
DK
NO
SE
FI
FR
GB
GB
61