Teach-Off Of The Room Control Unit From A Heating Zone; Teach-In With Alpha Ip Access Point; Configuration; Configuration With Altech V3 Ip Room Control Unit Display (S) - Altech V3 IP Mode D'emploi

Configuration

3. A room control unit can now be taught-in to the heating zones of the second base station, as de-
scribed in section 7.1 / 7.1.1.
7.4

Teach-off of the room control unit from a heating zone

1. Choose the channel through which the room control unit shall be taught-off, by a short press of the
Select key (B). Pressing 1x = HZ1 / Pressing 2x = HZ2.... Pressing 10x = HZ10
2. Press the System key (A) and the Select key (B) simultaneously until the LED of System key (A) lights
up in green.
If the room control unit is logged on to several Altech V3 IP base stations, this process
must be repeated for every base station.
3. Resetting the room control unit to factory settings (see manual of the respective room control unit).
7.5 Teach-in with Altech V3 IP Access Point
For a control via the IP app, the teach-on of the Altech V3 IP base station must be performed via the
Access Point (HAP 21001). Teach-in the device as follows:
Ö The Altech V3 IP Access Point has been set-up via the IP app (see manual HAP 21001).
4. Open the IP app on your smart phone.
DK
5. Select the menu item Teach-in device.
NO
6. Press the System key (A) shortly until the LED flashes slowly in orange. The teach-in mode is active
SE
for three minutes.
FI
7. The device will be displayed automatically in the IP app.
8. For confirmation, enter the last four digits of the device number (SGTIN) or scan the supplied QR
FR
code. The device number can be found below the supplied QR code or directly on the device.
GB
GB
The LED will light up in green after a successful teach-in process. The process must be repeat-
ed if the LED lights up in red.
9. Follow the directions of the app.
8 Configuration
The Altech V3 IP base station is configured via the Altech V3 IP room control unit Display, Display S,
or via the Altech V3 IP Access Point in conjunction with the IP app.
8.1

Configuration with Altech V3 IP room control unit Display (S)

Proceed as follows in order to configure the Altech V3 IP base station via the Altech V3 IP room
control unit Display (S):
1. Press and hold the setting wheel (E) in order to open the configu ation menu.
2. Select the symbol "
If the room control unit is taught-in to more than one base station, select the desired base
station with the setting wheel.
68
" and confirm the se ection by shortly pressing the wheel.