About These Instructions; Validity, Storage And Forwarding Of The Instructions; Symbols; Safety - Altech V3 IP Mode D'emploi

About these instructions

1 About these instructions
1.1

Validity, storage and forwarding of the instructions

These instructions apply to the Altech V3 IP Base Station. These instructions include information
nec-essary for the commissioning. These instructions must the read completely and thoroughly
before commencing any work with the device. These instructions must be kept and to be handed
over to future users.
1.2

Symbols

The following symbols are used in this manual:
Warning with respect to electrical voltage
Note:Identifi s important or useful information
Preconditions
Ö
Result from an action
9
• List without fi ed order
DK
1., 2. List with fi ed order
NO
SE

2 Safety

FI
2.1

Intended use

FR
The Altech V3 IP base station is a component of the Altech V3 IP Systems and serves
GB
GB
• for installation in environments of residential use,
• for the arrangement of a room-by-room temperature control system with a maximum of 10 zones
(depending on the type used) for heating and cooling systems,
• for the connection of a maximum of 15 actuators and 10 room control units (depending on the type
used),
• for the connection of actuators with the control direction NC (normally closed) or NO (normally
open),
• for the connection and the supply of a pump.
Every other use, modifi ation and conversion is expressively forbidden. Improper use leads to dangers
the manufacturer cannot be held liable for and will exempt guarantees and liabilities.
2.2

Safety notes

All safety notes in these instructions must be observed in order to avoid accidents with personal dam-
age or property damage. No liability is assumed for personal damage and property damage caused
by improper use or non-observance of the danger notes. In such cases any warranty claim is invalid.
There is no liability for consequential damages.
60