Siemens SITRANS F FUG1010 IP65 NEMA 4X Instructions De Service page 9

Qualified personnel
This flowmeter system may only be set up and used in conjunction with this manual and the
instructions on the electronic media provided. Installation, maintenance and operation of
the flowmeter system may only be performed by qualified personnel. Within the context of
this Manual, qualified persons are defined as persons who have the skills and knowledge
related to the construction and operation of the electrical equipment and installations and
have received safety training to recognize and avoid the potentially explosive hazards
involved.
Qualified personnel possess the following qualifications
1. Is trained and authorized to energize, de-energize, clear, ground and tag circuits and
2. Is trained in the proper care and use of protective equipment such as rubber gloves,
3. Is trained in rendering first aid
Note
This Manual does not purport to cover all details or variations in equipment, or to provide for
every possible contingency to be met in connection with installation, operation or
maintenance. Should further information be desired or should particular problems arise,
which are not covered sufficiently for the purchaser's purposes, the matter should be
referred to the local Siemens sales office (www.siemens.com). The contents of this manual
shall not become part of or modify any prior or existing agreement, commitment or
relationship. The sales contract contains the entire obligation of Siemens. The warranty
contained in the contact between the parties is the sole warranty of Siemens. Any
statements contained herein do not create new warranties or modify the existing warranty.
Safety Information for Hazardous Areas
Note
Ratings under this heading apply to specific model families
Check Your Model Number:
FUG1010, 7ME3610 only
FM-CSA installation
Read, understand and follow all safety instructions on the electronic media provided. This
equipment is rated for use in hazardous (classified) locations as stated below and must be
installed according to the 1010-304 installation drawing provided on the media. Failure to
install the equipment in the prescribed manner will result in unsafe operation. Follow all local
jurisdictional safety codes when operating this equipment. When properly installed the
equipment meets the following FM – CSA ratings.
FUG1010 IP65 NEMA 4X Quick Start
Operating Instructions, 06/2014, A5E02951527-AC
WARNING
equipment in accordance with established safety practices.
hard hat, safety glasses or face shields, flash clothing, etc., in accordance with
established safety practices.
Introduction
1.2 Safety Notes
7