Figure 3-1 Input Power (J10) Wiring - Siemens SITRANS F FUG1010 IP65 NEMA 4X Instructions De Service

Connecting
3.2 Transmitter Wiring
3. Locate power supply connector J10. Using a flat blade screwdriver, remove plug from
connector J10. Set aside.
①
Power Supply label
②
Power Supply Access Cover
③
Fuse F1
④
Input Power Conn J10
⑤
Connector mounting screws
Figure 3-1 Input power (J10) Wiring
4. Pull the desired length of input power wires through a cable gland and into transmitter
case before wiring connector.
5. Wire input power connector for AC or DC power depending on power supply provided.
Note
Dress cables and make sure cable length is not excessive as to impede proper
replacement of access cover.
6. Insert wires into wire entry holes and secure by tightening wire clamp screws (see figure
above).
Note
Power Supply connector wires should be stripped AWG 12 - 18 stranded wire or solid
conductors.
7. Plug input power plug into connector J10 and secure using two captive connector
mounting screws.
20
⑥
Wire Entry
⑦
Strip length 8mm (0.31 in)
⑧
Wire Clamp Screws
⑨
Ferrite power cord
Operating Instructions, 06/2014, A5E02951527-AC
FUG1010 IP65 NEMA 4X Quick Start