Focal FP 2.75 Manuel De Service page 199

5. Hints and tips
• Hardware connection errors
Note: In the event of such error messages being displayed, double check hardware, drivers, and restart
program. In the worst case please upgrade the firmware.
"Sensitivity setting error."
"Sensitivity reading error."
"Volume setting error."
"Volume reading error."
"Commutator setting error."
"Commutator reading error."
"Mode setting error."
"Mode reading error."
"Delay setting error."
"Delay reading error."
"Equalizer reading error."
"Equalizer setting error."
"Config reading error."
"Config writing error."
"Get input selector error."
"Set input selector error."
"Get headroom error."
"Set headroom error."
"Get config file name error."
"Set config file name error."
"Qbass reading error."
"Qbass setting error."
"Xover reading error."
"Xover setting error."
• Hardware upgrade errors
"Error of global JumpLoaderSection."
"Error of XXXXX flash programming."
"Error of XXXX eeprom programming."
For sensitivity.
For volume.
For commutator.
State of On/Off buttons.
For delay.
For equalizer.
For config.
For input selector.
For headroom.
For preset file name.
For QBass.
For crossover.
Error on entering upgrade mode.
Flash memory upgrade error for device XXXX.
Eprom memory upgrade error for device XXXX.
17