Simrad NSO evo3 Guide De Démarrage Rapide page 9

Autopilot
Activate the autopilot from any panel by selecting the autopilot option in the Control
bar, followed by selecting a mode in the Autopilot controller.
S
Standby
FU
Follow-up**
Non-Follow-
NFU
up
A
Heading hold
N
NoDrift
D
N
Navigation
W
Wind *
* Only available if the boat type is set to Sailboat.
** FU mode is only available if you have a remote controller included in the system.
¼ Note:
You switch the autopilot to Standby mode from any automatic mode by a
short press on the WheelKey configured for Autopilot control.
Adjust set heading / course / wind angle
Adjust set heading (Heading hold mode), set wind angle (Wind mode) and
set course (NoDrift mode):
•
Tap the port or starboard arrow indicators in the autopilot controller
Autopilot is passive. Used when manually steering at the helm.
Manual steering. The rudder angle is set by the Rotary knob or
by another FU unit.
Manual steering. The rudder movement is controlled by the
Port and Starboard buttons in the Pilot pop-up, or by another
NFU unit.
Automatic steering, maintaining the set heading.
Automatic steering, keeping the vessel on a straight bearing
line by compensating for drift.
Automatic steering, navigating the vessel to a specific
waypoint or through a route using GPS data.
Automatic steering, maintaining the set wind angle.
NSO evo3 | QuickStart Guide - EN
|
9