Connecting The Antenna; Basic Connections - Aiwa VX-S207U Mode D'emploi

PREPARATION

Connecting the antenna

Basic connections

VX-S207
1
Connect the antenna cable to the UHF/VHF connector on the unit.
If the cable is a round-type 75-ohm coaxial cable, connect it directly to the UHF/VHF connector.
If the cable is a flat-type 300-ohm twin-lead cable, connect it to the antenna adaptor (supplied), and connect the adaptor to
the UHF/VHF connector.
When you use VX-S137U, the antenna adaptor can be taken out from the supplied telescopic antenna.
2
Connect the AC cord to the AC wall outlet after passing it through the AC cord hook.
To use the security hook for safety (VX-S207 only)
To prevent the unit from falling during earthquakes, etc., affix the unit to a wall or pillar with the security hook on the rear using
the strong twine or wire.
VX-S207
UHF/
VHF
AC cord hook
2
UHF/
VHF
75-ohm
coaxial cable
(not supplied)
1
To AC outlet
Security hook
o
300-ohm twin-lead cable
(not supplied)
Antenna adaptor
(supplied)
CONTINUE
4
ENGLISH