Problem
Traces of rust on cutlery.
There are residues of detergent
in the dispenser at the end of
the programme.
Odours inside the appliance.
Limescale deposits on the ta-
bleware, on the tub and on the
inside of the door.
Dull, discoloured or chipped ta-
bleware.
Refer to "Before first use",
"Daily use" or "Hints and
tips" for other possible causes.
TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Possible cause and solution
• There is too much salt in the water used for washing. Re-
fer to "The water softener".
• Silver and stainless steel cutlery were placed together.
Avoid to put silver and stainless steel items close together.
• The detergent tablet got stuck in the dispenser and there-
fore was not completely washed away by water.
• Water cannot wash away the detergent from the dispens-
er. Make sure that the spray arm is not blocked or clog-
ged.
• Make sure that items in the baskets do not impede the lid
of the detergent dispenser from opening.
• Refer to "Internal cleaning".
• The level of salt is low, check the refill indicator.
• The cap of the salt container is loose.
• Your tap water is hard. Refer to "The water softener".
• Even using multi-functional tabs use salt and set regener-
ation of the water softener. Refer to "The water soften-
er".
• If lime scale deposits still remain, clean the appliance with
appliance cleaners which are particularly suitable for this
purpose.
• Try different detergent.
• Contact the detergent manufacturer.
• Make sure that only dishwasher-safe items are washed in
the appliance.
• Load and unload the basket carefully. Refer to basket
loading leaflet.
• Place delicate items in the upper basket.
Width / height / depth (mm)
Voltage (V)
1)
Frequency (Hz)
Min. / max. bar (MPa)
Cold water or hot water
Place settings
596 / 818-898 / 550
200 - 240
50 / 60
0.5 (0.05) / 8 (0.8)
max 60 °C
2)
13
19