Technical Data; General Instructions - Paoli RED DEVIL 2.0 Mode D'emploi

TECHNICAL DATA

DESCRIPTION
Portable air impact wrench designed for
motorsport application (Best Practice: Nascar).
LUBRICANT
Hammer mechanism lubrication: Special grease
for Paoli air impact wrench hammer mechanism.
Air motor lubrication: Very fluid oil for air
tools or Special oil for Paoli air impact wrench
motors.
ENVIRONMENTAL CONDITIONS
Temperature: -5 ° C ÷ + 45 ° C
Storage temperature: 0 ° C ÷ + 40 ° C
Air humidity: <80%
Max Altitude: 2000m from sea level
AIR SUPPLY SYSTEM
DIAGRAM
View figure Fig.3.
L It is allowed to use exclusively on industrial
plants with compressed air.
L Make use of a supply system that observes
the indicated pressure values (max 10%
over the maximum value indicated) using an
air pressure regulator supplied by a system
observing the current safety standard, and
that it is subjected to regular checks.
L The components of the supply system must
be designed and constructed in accordance
with the safety requirements contained in
current international standards.
L Before any work on the supply system, always
check that the line is depressurized (no air
pressure).
L Fit a supply hose with standard female fast
connection for compressed air to the whip
hose of the Red Devil 2.0
L Use a supply pipe of minimum inner diameter
0,375" (3/8 inch).
ENGLISH
4
OPERATING AND MAINTENANCE MANUAL
®
air gun.
INTENDED USE
Assembly air tool for threaded fasteners in the
pit stop service.
Weight
Length
Square drive
Air inlet
Supply hose inside diameter
Maximum free speed (RPM)
Operating air pressure
Ultimate torque

GENERAL INSTRUCTIONS

L Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L Do not operate the wheel gun without the
prescribed safety devices.
L The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L Verify that the WARNING label
Fig.2-A) is present and legible, otherwise
replace it by applying new one in the original
position.
L Do not use the wheel gun with the screws of
the clutch cover (view figure Fig.2-A
motor cover (view figure Fig.2-A
not tight enough (see table Tab. A "Tightening
Torques"). If not tighten them with a torque
wrench following the tightening sequence
shown (view figures Fig.2-E and
L Pay attention to the exhaust coming out
by the wheel gun during operation
figure Fig.2-B). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
2,35 kg (5.2 lbs)
197 mm (7.75")
1/2"
AA 59439 former U.S. Standard
MIL C 4109 3/8" / ISO 6150B
10 mm (0.39")
14.500 (175 psi, 12 bar)
175 psi (12 bar)
1100 Nm (812 ft-lbs)
(view figure
"E") or the
"P") loose or
Fig.2-F).
(view