FAR Farelek 112500 Mode D'emploi page 54

INSTALLATION
2
Connections
Screw the nuts of the connection pipe using
•
a spanner (tightening force given below)
REMARQUES
Pipe
Liquids pipe
Gas pipe
Gas pipe
3
Filters
112500-504-D
1 - The number of curves of the pipe of the internal unit 1 - The number of curves of the pipe of the internal unit 1 - The number of curves of the pipe of the internal unit 1 - The number of curves of the pipe of the internal unit
must not exceed 10.
2 - The number of curves of the pipe of the internal unit and 2 - The number of curves of the pipe of the internal unit and 2 - The number of curves of the pipe of the internal unit and 2 - The number of curves of the pipe of the internal unit and 2 - The number of curves of the pipe of the internal unit and
external unit must not exceed 15. external unit must not exceed 15. external unit must not exceed 15. external unit must not exceed 15.
3 - The radius of curvature must be greater than 10 cm. 3 - The radius of curvature must be greater than 10 cm. 3 - The radius of curvature must be greater than 10 cm. 3 - The radius of curvature must be greater than 10 cm.
Pipe diameter Pipe diameter Pipe diameter Pipe diameter
6,35 mm (1/4") 6,35 mm (1/4") 6,35 mm (1/4") 6,35 mm (1/4")
9,52 mm (3/8") 9,52 mm (3/8") 9,52 mm (3/8") 9,52 mm (3/8")
12,7 mm (1/2") 12,7 mm (1/2") 12,7 mm (1/2") 12,7 mm (1/2")
© FAR GROUP EUROPE 2004
54
Application force (N.M) Application force (N.M)
• Put the filters (green) in place in the
cartridges, then re-close the cartridges
(closed by clipping).
• Open the cover of the internal unit, then
take out the flexible grids.
• Put the filters in place in their housings
(runners).
• Put back the grids, then re-close the cover
of the unit.
17/05/04, 17:04
GB
13,7 à 17,6
34,3 à 41,2
49 à 56,4