Installation Of The Internal Unit - FAR Farelek 112500 Mode D'emploi

Table des Matières

Les langues disponibles

INSTALLATION

Installation of the emptying hose

1 - NOTE

• The emptying hose must be placed under the copper pipe.

• The emptying hose must not be curved or bent.

• Do not retrieve the emptying hose by pulling.

• If the emptying hose has to cross the house, it must be

enveloped with specific insulating materials.`

• The copper pipe and the emptying hose must be enveloped

The copper pipe and the emptying hose must be enveloped

by a felt strip. Use insulating plates at the contact points

between the pipe and the wall.

2 - POSITIONNING THE PIPES

• If the pipe exits from the right side of the inter-

If the pipe exits from the right side of the inter-

nal unit, cut the «1» section of the unit.

• If the pipe exits from the lower right side of the

If the pipe exits from the lower right side of the

internal unit, cut the «2» section.

• If the pipe exits from the left side of the internal

If the pipe exits from the left side of the internal

unit, cut the «3» section.

3 - INSTALLATION OF THE EMPTYING HOSE

• If the pipe exits from the left side of the internal

If the pipe exits from the left side of the internal

unit, the emptying hose must be reinserted in order to

avoid water leaks.

• Methods for reinsertion: change the positions of the

Methods for reinsertion: change the positions of the

emptying hose and the emptying tap. the right-hand diagram

shows the usual position.

• Do not discharge after reinsertion because this could result in water leaks.

Do not discharge after reinsertion because this could result in water leaks.

WARNING : During reinstallation, the emptying pipes and hoses must be taken out through the

During reinstallation, the emptying pipes and hoses must be taken out through the

first position, to avoid electrocution risks.