Lubricating The Stripping Grade Adjustment Wheel - Weidmüller Crimpfix E Notice D'instructions Originale

7.10 Lubricating the stripping grade adjustment
wheel
► Make sure that the machine is switched off.
► Remove the power plug.
Detach the housing:
► Open the front flap.
► Remove all housing screws that are not provided with
locking paint (red).
► Remove the earthing wire that connects the housing
with the flat plug distributor by pulling it out of the dis-
tributor.
Figure 7.8 Flat plug distributor
► Place the machine on its left side.
Figure 7.9 Machine lying on its left side
2516390000/03/07.2018
► Spray Teflon spray in the gap between adjustment
wheel and cover.
► Turn the adjustment wheel with the Allen key until
end-to-end lubrication can be detected.
Figure 7.10 Gap
► Lubricate the spherical pressure pieces (2) with the
Teflon spray.
► Spray the Teflon spray under the screw head (3) with-
out releasing the screw.
2
Figure 7.11 Lubrication points
Potential risk of fatality due to electric
shock!
► Put the earthing wire back on the flat
plug distributor when installing the hous-
ing.
► Assembly in reverse order.
Cleaning and maintaining the machine
3
WARNING
45