Setting The Crimping Die Size - Weidmüller Crimpfix E Notice D'instructions Originale

5.3 Setting the crimping die size
1. Turn the lock on the front flap to open it.
2. Swing the front flap to the side.
2.
Figure 5.3 Housing parts
A sticker is located on the inside of the front flap with the
setting values for the crimping die.
Figure 5.4 Crimping die size sticker
2516390000/03/07.2018
1.
Figure 5.5 Setting the die size
► Press the drum (3) to the left and turn it until it latches
The currently set crimping die is indicated using Roman nu-
merals (I-III) and parallel in the touch display.
► Check that the drum is latched in properly by attempt-
3
into the desired die size (4) (see also figure 5.4).
ing to turn it.
Setting up the machine
4
37