Cleaning And Maintaining The Machine; Cleaning The Machine Externally; Machine Maintenance - Weidmüller Crimpfix E Notice D'instructions Originale

7

Cleaning and maintaining the machine

7.1 Cleaning the machine externally
The machine should be freed of dust on a regular basis.
If necessary, it may have to be cleaned outside.
Cleaning the inside is part of maintenance
which must only be carried out by trained
personnel.
► Make sure that the machine is switched off.
ATTENTION
The display may become damaged!
Using unsuitable cleaning agents may scratch or damage
the display.
► Clean the display carefully, either using a special
cleaning cloth for display surfaces, or with a soft cloth
and some display cleaner.
► Clean the surface of the machine with a damp cloth.
► If necessary, use soap-based cleaning agents. Do not
use any abrasive cleaners or solvents.
2516390000/03/07.2018

7.2 Machine maintenance

In order to ensure fault-free operation, the following main-
tenance tasks (see section 7.3) must be performed at the
specified intervals.
Potential risk of fatality due to electric
shock!
When working on the inside of the machine,
non-insulated parts may be touched.
► Switch the machine off.
► Pull the power plug.
In order to be able to access all the areas inside
the machine easily, you should remove the waste
container when starting maintenance work. Re-
member to put it back in once work is complete.
Keep the following ready for maintenance work:
– Allen key set
– Brush and cleaning cloth
– Lubricant
– Oil (suitable for rolling bearings)
– Lubricating grease (suitable for rolling
bearings)
Recommended grease:
BP Energrease PR-EP 00
Recommended spray:
Teflon spray
WARNING
41