Removing Ferrules; Replacing Fuses; Status Menu - Weidmüller Crimpfix E Notice D'instructions Originale

8.6 Removing ferrules
► Open the front flap.
► Remove the transport unit (see section 8.5).
► Search and remove the ferrule.
► Reinstall the transport unit.
► Close the front flap.
► Briefly press the touch display.
8.7 Replacing fuses
► Make sure that the machine is switched off.
► Remove the power plug.
Figure 8.6 Opening the fuse compartment
► Lever out the fuse compartment (1) using a slotted
screwdriver.
► Replace both fuses with new ones (2 x T2AH250V).
► Put the fuse compartment back into the mains filter
unit.
2516390000/03/07.2018

8.8 Status menu

The menu is used for displaying the status of the inputs (0 or
1) on the machine.
► Set the stripping level to 99.
► Press the touch display for 3 seconds.
The status of filling level monitoring is displayed.
► Press the touch display again for 3 seconds.
The status of all inputs is displayed.
I1 = 0
I2 = 1
I3 = 1
I4 = 0
1
I1 Start: Microswitch
I2 Drum position
I3 Drum position
I4 Drum position
I6 Stop: Light barrier
I7 Front flap
I8 Ferrule control
► To exit the menu again, press the touch display for
3 seconds.
► Select the stripping level with which you wish to work.
Troubleshooting
I6 = 0
I7 = 0
I8 = 1
51