Operation; Replacing The Power Cable; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL RT-AP 1050E Mode D'emploi D'origine

Anleitung_RT_AP_1050_E_SPK7:_
GB

6. Operation

6.1 ON/OFF switch (Fig. 1/Item 1)
To switch on:
Press the ON/OFF switch
To switch off:
Release the ON/OFF switch
6.2 Locking button (Fig. 1/Item 2)
You can lock the ON/OFF switch (1) using the locking
button (2) when the equipment is in operation. To
switch off the equipment briefly hold down the
ON/OFF switch (1).
6.3 Function switch (Fig. 4-6/Item 7)
Important. Activate the function switch (7) only
when the equipment is at a standstill.
You can move the soleplate (5) to 4 different settings
to work better in hard-to-reach areas.
To move the soleplate (5), set the function switch (7)
to position A (see Figure 4).
To lock the soleplate (5) in place, set the function
switch (7) to position B (see Figure 5). The soleplate
(5) can be locked in only four positions (at 90°, 180°,
270° and 360°). Now check that the soleplate (5) is
secure by turning it.
The pendulum action is activated in position C (see
Figure 6). The saw balde will then move forwards and
backwards in addition to its up and down movements.
This will improve the sawing performance through
better chip discharge. In this position the soleplate (5)
is always locked.
Important. To switch the function switch (7) to
position C, the soleplate (5) must be set to 180° or
360°.
14
05.09.2011 16:53 Uhr Seite 14
6.4 Use as a jigsaw (Fig. 7)
Place the multi-saw on the material to be cut as
shown in Fig. 7. Switch on the multi-saw and push it
along against the material to be cut. Adapt your
cutting speed to the material.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info