Rear Exit; Rear Exit Shield (For Rear Vent Only) - Continental Fireplaces CB30-1 Manuel D'installation Et D'opération

venting requirements
EN
2.10

rear exit

WARNING
!
• Failure to create a seal to the firebox with the exhaust collar assembly will cause the appliance to function
improperly and can cause injury or property damage.
Remove the safety barrier and glass front, refer to "safety
A.
barrier & door removal/installation" section.
Remove the contents from the firebox and set aside, you will
B.
need the exhaust flue collar from the top of the log carton.
To ease assembly, remove the four hex head screws
C.
securing the deflector from inside the top front of the firebox,
refer to Figure 1.
Place the gasket (provided) over the 4" (102mm) flue collar
D.
assembly and bend along perforation.
From inside the firebox, insert the 4" (102mm) flue collar through the back
E.
of the firebox. Install the rear exit shield onto the 4" (102mm) flue collar, see
"rear exit shield" section for installation instructions.
Secure the flue collar assembly, gasket and rear exit shield using the four hex
F.
head 3/8" thread cutting screws, refer to Figure 2.
note:
Do not overtighten. The gasket needs only
to be snug against the firebox.
Reattach the deflector using the four screws
G.
and install the log set, glass door and safety
barrier.
Install the 7" collar assembly, complete with
H.
gasket, onto the rear panel around the 4"
(101.6mm) collar with the screws provided
(FIG 3).
2.11

rear exit shield (for rear vent only)

Remove the safety barrier assembly and door from the appliance, refer to "safety barrier & door
A.
removal / installation" section.
Loosen the two screws, that secure the exhaust plate, and slide the shield in place by sliding its slotted
B.
openings behind the screwheads,
tighten the two previously loosened
screws. Refer to the illustration.
Reinstall the door and safety barrier
C.
assembly on the appliance, refer to
"safety barrier & door removal /
installation" section.
note:
This shield is used to block the view
through the venting to the outdoors.
22
W415-2754 / B / 12.09.20
Fig. 1
DEFLECTOR
DÉFLECTEUR
Fig. 2
Fig. 3
GASKET
INTAKE COLLAR
ASSEMBLY