Rear Exit Shield (For Rear Vent Only) - Continental Fireplaces X 36 Série Manuel D'installation

venting requirements
EN
2.11

rear exit shield (for rear vent only)

A.
Remove the safety barrier assembly and door from the appliance, refer to the "safety barrier & door
removal / installation" section of the manual for detailed instructions.
B.
Loosen the two screws, that secure the exhaust plate, and slide the shield in place by sliding its
slotted openings behind the screwheads, tighten the two previously loosened screws. Refer to the
illustration below.
C.
Reinstall the door and safety barrier assembly on the appliance, refer to the "safety barrier & door
removal / installation" section of the manual for detailed instructions.
f i r e - p a r t s . c o m
note:
This shield is used to block the view through the venting to the outdoors.
24
W415-1850 / A / 03.06.19