Additional Safety Instructions - Hilti SF 2-A12 Notice D'utilisation Originale

to rotate freely without contacting the workpiece, resulting in personal
injury.
▶ Apply pressure only in direct line with the bit and do not apply
excessive pressure. Bits can bend causing breakage or loss of control,
resulting in personal injury.
2.3 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and
use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject
them to temperatures over 80 °C (176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact,
have been dropped from a height or show signs of damage. In this case,
always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in
a place where it is clearly visible and where there is no risk of fire, at an
adequate distance from flammable materials. Allow the battery to cool
down. If it is still too hot to touch after an hour, the battery is faulty.
Contact Hilti Service.

2.4 Additional safety instructions

Personal safety
▶ Use the product only when it is in perfect working order.
▶ Never tamper with or modify the tool in any way.
▶ Do not look directly into the light source (LEDs) integrated in the drill/driver
and do not direct the light at other persons' faces. This presents a risk
of dazzling or eye damage.
▶ Avoid touching rotating parts. Switch the power tool on only after
bringing it into position at the workpiece.
especially rotating accessory tools, may lead to injury.
▶ Wear protective gloves also when changing the accessory tool. Touching
the accessory tool presents a risk of injury (cuts or burns).
▶ Always hold the tool securely by the grip. If the accessory tool (e.g. the
drill bit) sticks and stalls, the power tool, due to its high torque, may
tend to rotate about its own axis in the direction opposite to that of the
accessory tool.
▶ Make sure that the workplace is well ventilated and, where necessary,
wear a respirator appropriate for the type of dust generated. Contact with
or inhalation of the dust may cause allergic reactions and/or respiratory
or other diseases to the operator or bystanders. Certain kinds of dust
are classified as carcinogenic such as oak and beech dust, especially
in conjunction with additives for wood conditioning (chromate, wood
*2235450*
2235450
Touching rotating parts,
English 7