ResMed AirFit N10 Guide D'utilisation page 9

Cleaning your mask in your home
Your mask and headgear should only be handwashed by gently rubbing in
warm (approximately 86°F/30°C) water using mild soap. All components
should be rinsed well with drinking quality water and allowed to air dry
out of direct sunlight.
WARNING
Always follow cleaning instructions and use mild soap. Some
cleaning products may damage the mask, its parts and their function,
or leave harmful residual vapours that could be inhaled if not rinsed
thoroughly.
CAUTION
If any visible deterioration of a system component is apparent
(cracking, crazing, tears etc), the component should be discarded and
replaced.
Daily/After each use:
• To optimize the mask seal, facial oils should be removed from the
cushion after use.
• Handwash the separated mask components (excluding headgear and
soft sleeves).
• If the vent or swivel requires cleaning, use a soft bristle brush.
Weekly:
• Handwash the headgear and soft sleeves. The headgear may be
washed without being disassembled.
Reprocessing the mask between patients
Only Sleep Lab Mask (SLM) variants of the mask are intended for
multi-patient re-use. When using between patients, these masks must be
reprocessed according to cleaning and disinfection instructions available
on ResMed.com/downloads/masks.
English 5