Sony RM-IP10 Mode D'emploi page 8

S SELECT button
The camera group number can be changed by
pressing the GROUP/POSITION button while this
button is pressed. To select camera group numbers
9 to 16, press and hold the SHIFT button (the lower
indicator lights).
The SELECT button works only for the LAN
connection.
T POWER button
Press this button to light the CAMERA button(s)
corresponding to the status of the connected
camera(s).
Yellow: The power of the camera is on.
Green: The camera is in standby mode.
Off: No camera is connected.
Hold down this button and press CAMERA buttons
1 to 7 to turn on/off the power of the camera
corresponding to the pressed button.
U CAMERA buttons
Press one of the buttons to select the camera from
among those connected. The selected CAMERA
button lights in yellow.
V GROUP/POSITION buttons
You can store various camera settings such as the
pan, tilt and zoom positions to the memory of the
camera corresponding to each GROUP/POSITION
button, and load the settings in the memory.
This buttons are also used for selecting the camera
group number when connecting over a LAN.
8
GB
Location and Function of Parts
Rear
MODE LAN
wd wfwg wh wj wk wl
W MODE selector
Select the position corresponding to the camera to
be connected.
Switch position Camera mode
0 Automatically selected (default)
1 Not used
2 Not used
3 Not used
4 Not used
5 Not used
6 Not used
7 BRC-Z700
8 BRC-Z330
9 BRC-H900
Note
Use positions 7 to 9 when all the connected cameras
are of the same model. In other cases, use position
0.
X LAN connector (RJ-45 8-pin)
For LAN connection.
Connect a LAN HUB (10BASE-T/100BASE-TX),
using a LAN cable (category 5 or higher).
When a link is established, the green indicator
lights, and it flashes during communication. While
connected with 100BASE-TX, the yellow indicator
also lights.
Notes
• For safety, do not connect the connector for
peripheral device wiring that might have
excessive voltage to this port. Follow the
instructions for this port.
• When you connect the LAN cable of the unit to
peripheral device, use a shielded-type cable to
prevent malfunction due to radiation noise.
!
RS-232C RS-422 TALLY/CONTACT
VISCA
1 9 1 9
DC 12V
e;