Viking 5 Série Manuel D'installation, D'utilisation Et D'entretien page 14

Operating Instructions
STORAGE BIN ADJUSTMENT
Storage Bin Removal
1. Empty and remove bin.
2. Firmly grasp both sides of storage bin frame and lift
front end slightly (about ¼ ") to center the pin in the slot.
3. Pull frame towards you until all pins are clear of the
slots. If only repositioning the frame, do not remove
completely - go to "Storage Bin Installation" Step 2.
4. Slightly tilt one side. Gently pull frame towards you to
remove from unit.
Note: Take care when removing frame to avoid scratching
interior of unit.
Center
the pin
5. Once removed, retract the slides.
Note: The slides on the frame have a thin coating which is
used to block moisture and provide lubrication. Use care
when handling.
Slide and Secure Storage Bin Installation
1. Insert empty storage bin frame into unit with one side
tilted slightly downward until back pin is between front
and rear rail supports.
2. Tilt frame back to horizontal and line up 2 back pins
with rear rail support. Line up left side of frame with rear
and front rail support. Continue inserting frame until
both pins engage. The front will set down slightly and
lock into place. Repeat on right side.
Back Pin
3. Fully extend frame, position bin over frame and lower
(rear fi rst) into position.
Storage bins
Glass inserts are designed so bottles and cans sit fl at. The
inserts may be removed when storing produce or other
items. The ridges in the bottom facilitate air fl ow.
Clean the storage bins with soap and water.
14
Center
the pins
Front Pin