Marantz professional Turret Guide D'utilisation page 6

Operation
Camera
Before using the camera, make sure you have selected Turret as a video capture device in your
computer and software. See Video Setup for more information.
To turn the camera on or off, press the Camera On/Off button. When the camera is on, the button
and camera LEDs will be lit blue. When the camera is off, the button and camera LEDs will not be lit.
LED Ring Light
To turn the LED Ring Light on, turn the Brightness knob to the right from its left-most position until
you hear a "click."
To adjust the Brightness of the LED Ring Light, turn the Brightness knob. Turn the knob to the
right to increase the brightness, or turn it to the left to decrease the brightness.
To turn the LED Ring Light off, turn the Brightness knob all the way to the left until you hear a
"click."
Filters
To attach a filter to the LED Ring Light, align the filter so the tab at the bottom of the filter is aligned
with the notch at the bottom of the LED Ring Light, and then snap it into place.
Note: Remove the plastic film from the lighting filter before use.
To remove the filter, use the tab to pop it out from the LED Ring Light.
Microphone
Before using the microphone, make sure you have selected Turret as your audio recording device in
your computer and software. See Audio Setup for more information.
Muting/Unmuting
To mute or unmute the microphone, press the Microphone On/Off button. When the microphone
is on (unmuted), the button and microphone LEDs will be lit blue. When the mic is off (muted), the
button LED will turn off, and the microphone LED will flash red.
Mic Sensitivity
To adjust the sensitivity of the microphone, use the Microphone Sensitivity switch on the bottom
of the microphone. Set this switch to 0 dB for normal operation. For situations where the sound input
is sufficiently loud enough that it may overdrive some part of the audio signal chain, set this switch to
-10 dB. This will reduce the overall microphone volume.
6