Commissioning - SOMFY ilmo2 50 WT Mode D'emploi

EN
Example for a 3A control point:
To integrate a motor into a Somfy system, using a Somfy motor controller, the connection
requirements in the controller manual must be followed carefully.
Controllers with "semiconductor" relays must not be used.

2. 3. COMMISSIONING

A er having a xed the roller shutter to the roller tube,
check that when the roller shutter is in the lower end limit
position, the rigid link is correctly positioned and that the
first slat is vertically between the runners (as per F). If
necessary, adjust the number of slats used to improve the
position of the rigid link when the roller shutter is in the
lower end limit position.
Always refer to the manufacturer's size and weight charts
and fitting recommendations for the rigid links to select
those suited to the roller shutter used.
Use at least 2 rigid links to attach the roller shutter to the roller tube.
Switch the power back on.
1)
Press the "Up" button at the control point:
-
If the roller shutter rises, the wiring is correct and
•
commissioning is finished.
If the roller shutter is lowered, go to the next step.
•
Switch o the power.
2)
Reverse the brown wire and the black wire connected to the
-
control point.
Switch the power back on.
3)
Press the "Up" button to check the direction of rotation.
-
Images not contractually binding
18
Torque in Nm Maximum number of motors
6
10
20
F
F
1
ON
2
OFF
3
ON
Copyright © 2015 Somfy SAS. All rights reserved.
5
4
2
OK
2
OK